Table of Contents
Advertisement
Figure 61. Removing the M.2 SSD from BOSS S1 card carrier
Next steps
1.
Replace the M.2 SSD into the BOSS S1 card module.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the
air shroud.
NOTE:
The procedure to install the BOSS S1 card is similar to the removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the BOSS S1 card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS S1 card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
65
Advertisement
Table of Contents
