Installing An Expansion Card Riser - Dell 0G8DW Installation And Service Manual

Figure 49. Removing the expansion riser 2B
Next step
Install the expansion card riser.

Installing an expansion card riser

Prerequisites
1 Follow the safety guidelines listed in
2 Before installing the expansion card riser 2A, install an expansion card into the riser, if applicable.
Steps
1 If removed, install the expansion cards into the expansion card
2 Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
NOTE: While installing riser 1B, press the tabs and hold the touch point to align the expansion card riser and the riser
guide pin on the system board.
3 Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
108 Installing and removing system components
Safety instructions.
riser.