Table of Contents
Advertisement
9. If you are not replacing the power supply, install the cover over the slot. To install the cover, insert
your thumb and forefinger into the finger holes of the cover, squeeze to retract the spring latches, and
place the cover in the slot. Do not run the chassis without a power supply or cover in place.
10. Unscrew the screw on the plastic cable cover that shields the input terminal studs counterclockwise
by using the Phillips (+) screwdriver, number 2.
11. Unscrew the nuts counterclockwise, using the 13/32 in. (10 mm) nut driver or socket wrench, from
the input terminal studs.
12. Remove the cable lugs from the input terminal studs.
RELATED DOCUMENTATION
JNP10K-PWR-AC2 Power Supply | 54
JNP10K-PWR-DC2 Power Supply | 56
Connect AC Power to a PTX10004 | 149
Connect DC Power to a PTX10004 | 150
Calculate Power Requirements for a PTX10004 Router | 90
PTX10004 Field-Replaceable Units | 35
Install and Remove PTX10004 Switch Fabric
Components
IN THIS SECTION
How to Handle and Store PTX10004 SIBs | 196
Install a PTX10004 Switch Interface Board | 198
Remove a PTX10004 Switch Interface Board | 203
Each PTX10004 router contains a minimum of three and a maximum of six Switch Interface Boards (SIBs)
that are installed vertically, mid-chassis, between the line cards and the Routing and Control Boards (RCBs)
195
Advertisement
Table of Contents
