Jnp10K-Pwr-Dc2 Power Supply Leds - Juniper PTX10004 Hardware Manual

Table 17: JNP10K-PWR-AC2 LEDs on a PTX10004 (continued)
LED
OK (Power OK)
! (Fault)

JNP10K-PWR-DC2 Power Supply LEDs

A JNP10K-PWR-DC2 power supply has four LEDs on its faceplate: 1, 2, OK, and the symbol for fault, !.
These LEDs display information about the status of the power supply. See
Figure 22: LEDs on a JNP10K-PWR-DC2 Power Supply
1 ! Fault
—
2 OK Power OK
—
Table 18 on page 61 describes the LEDs on a JNP10K-PWR-DC2 power supply.
Color State
Green Solid
Yellow Blinking
Red Solid
Unlit Off
1
2
3
4
Description
The power supply is functioning properly.
The power supply output has detected a fault.
The power supply has failed and must be replaced.
The power supply is functioning normally.
Figure 22 on page
3 2 Power source input 1
—
4 1 Power source input 0
—
60
60.