Table of Contents
Advertisement
CAUTION:
update the installation base data if there is any addition or change to the installation
base or if the installation base is moved. Juniper Networks will not be held accountable
for not meeting the hardware replacement service-level agreement for products that
do not have registered serial numbers or accurate installation base data.
Register your product(s) at https://tools.juniper.net/svcreg/SRegSerialNum.jsp.
Update your installation base at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp.
Install the Mounting Hardware for a PTX10004
You can install a PTX10004 router in a four-post closed frame rack or a four-post open frame rack. Install
the mounting hardware on the rack before you install the router.
To mount the chassis on a four-post rack, you must first install the mounting hardware in the rack. The
PTX10004 router comes with a four-piece set of brackets that supports the chassis in the rack. You can
order the rack mount kit, JNP10004-RMK-4POST, as a spare.
NOTE:
Two-post installation racks are not supported.
The rack mount kit contains the following main pieces:
One mounting tray—The mounting tray is a solid sheet-metal shelf that supports the full weight of the
router. It attaches to the front of the rack and to the two adjustable mounting blades that attach to the
rear of the rack.
Two mounting blades—These adjustable mounting brackets allow you to custom fit the mounting tray
to different rack depths up to 31.5 in. (800 mm)..
One safety restraint—The rear restraint ensures that the chassis is immobile in case of an earthquake.
Ensure that you have the following parts and tools available to install the mounting hardware:
A Phillips (+) screwdriver, number 1, 2, or 3, depending on the size of your rack screws
A Phillips (+) screwdriver, number 2, to install the screws that connect the mounting tray and mounting
blades
Register product serial numbers on the Juniper Networks website and
126
Advertisement
Table of Contents
