Install A Ptx10004 Routing And Control Board - Juniper PTX10004 Hardware Manual

Install a PTX10004 Routing and Control Board

In redundant configurations, a PTX10004 RCB is a hot-removable and hot-insertable field-replaceable
unit (FRU). In base configurations, you need to install a second RCB before you remove a failing RCB to
prevent the router from shutting down.
Before you install an RCB, ensure that you have an electrostatic discharge (ESD) grounding strap.
To install an RCB:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist and connect the other
end of the strap to one of the ESD points on the chassis (see
Figure 68: ESD Point on the Front of the PTX10004 Chassis
LINK
STS
ToD
1PPS
10MHz
MGMT
BITS-0
1 ESD point
—
2. Either remove the cover from the available RCB slot (see
RCB, (see "Remove a PTX10004 Routing and Control Board" on page
Figure 69: Remove an RCB Cover
IN
Figure 68 on page
1
Figure 69 on page
164).
162).
162) or remove the failing
162