Swing Flap Motor; Main Swing Flap Motor - Daikin RXTA30B2V1B Service Manual

4 | Components

4.20 Swing flap motor

4.20.1 Main swing flap motor

Checking procedures
To perform an electrical check of the swing flap motor
Service manual
170
Is the problem solved?
No
FTXTA-B units
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Disconnect the swing flap motor connector from the indoor unit main PCB.
2 Measure the resistance between the following pins of the motor connector.
Result: The measurements MUST be as shown in the table below.
Pins
1-2
1-3
1-4
1-5
2-3
2-4
2-5
3-4
3-5
4-5
Swing flap motor resistance
measurements are correct?
Yes
No
3 Remove the swing flap motor, see
4 Measure the resistance between the following pins of the connector on the
swing flap motor.
Result: The measurements MUST be as shown in the table below.
Action
Return to the troubleshooting of the
specific error and continue with the
next procedure.
"4.17 Plate
Measured resistance (Ω)
353.4~406.6
653.6~866.4
Action
Return to the troubleshooting of the
specific error and continue with the
next procedure.
Continue with the next step.
4
"Repair procedures" [ 174].
RXTM-R+RXTP-R+ARXTP-R+RXTA-B+FTXTA30B2V1B(W)
(B)+FTXTM30+40R2V1B+FTXTP25+35M5V1B+ATXTP25+35M5V1B
4
work" [ 144].
R32 Optimized Heating 4 Split
ESIE21-12A – 2022.02