Table of Contents
Advertisement
Ping
Select P
is available only with ethernet card installed.
Address to Ping (PING ADDRESS)
Enter the IP address of the unit the TSU IQ+ is sending an echo
request (ping) to.
Start Ping
Results are shown once you start the ping. The S
command causes the TSU IQ+ to send ten ping requests to the
target station. At the end of the ten-ping test, the following results
are shown:
Pings Transmitted (PINGS TX)
This field shows the number of pings sent (always 10).
Ping Responses (PINGS RX)
This field shows the number of responses received from the pinged
device.
Min Response Time (MIN RESP TIME)
This field shows the shortest round-trip delay (in ms) of the
received responses. Round-trip delay is counted from the time the
ping is sent until the response is received.
Max Response Time (MAX RESP TIME)
This field shows the longest round-trip delay (in ms) of the
received responses. If a response is not received before the unit
times out, the delay is not calculated in.
Avg Response Time (AVG RESP TIME)
This field shows the average response time (in ms) based on all
received responses.
61200275L1-1
to send a ping request to a specific address. This option
ING
TSU IQ+ User Manual
Chapter 11. Testing
P
TART
ING
11-3
Advertisement
Table of Contents
