Table of Contents
Advertisement
Management DLCI (MGMT DLCI)
To use local PVC management, enter the management data link
connection identifier (DLCI). The M
DLCI used between the attached DTE device and the TSU IQ+ to
carry SNMP and TELNET packets to/from the TSU IQ+ on the
DTE port.
Guidelines for Configuring Management DLCI
If the attached router or FRAD is used to route SNMP/TELNET
frames to the TSU IQ+, set the M
value (between 16 and 1007) that identifies the virtual circuit
between the router/FRAD and the TSU IQ+. The router/FRAD
must also be configured to route the TSU IQ+ IP address to this
DLCI. The IP A
must also be set in the S
Management PVC Option (MGMT PVC OPT)
If this option is set to E
in the Full Status response to the router. Enable this option when
the management DLCI is used to route management traffic to the
TSU IQ+. Options are E
Signaling Responses (SIG RESPONSES)
This option determines when PVC S
to the router.
Always On
If enabled, PVC S
regardless of the network signaling state. Enable this option when
the TSU IQ+ is used for dial backup.
Follow Network (FOLLOW NET)
If enabled, PVC S
when the network signaling state is up. Enable this option when
the router is going to use an alternate path for dial backup.
Always Off
If enabled, PVC signaling responses are NOT sent to the router,
regardless of the network signaling state. Enable this option to
simulate a PVC failure when the router is going to use an alternate
path for dial backup.
61200275L1-1
ANAGEMENT
and S
DDRESS
UBNET
C
YSTEM
ONFIGURATION
, the management DLCI is included
NABLED
and D
NABLED
R
IGNALING
ESPONSES
R
IGNALING
ESPONSES
TSU IQ+ User Manual
Chapter 6. Data Port Configuration
DLCI is a special
ANAGEMENT
DLCI to a unique
M
for the DTE (
ASK
menu.
.
ISABLED
R
IGNALING
ESPONSES
are sent to the router
are sent to the router only
) port
V.35
are sent
6-5
Advertisement
Table of Contents
