Dmx - Barco UDX User Manual

Image 10–26 Example of entering the IP address
4. Use the arrow keys and enter key to enter in the IP address.
Note: Digits can be entered with the digit keys on the remote control or the local keypad. When a
digit is entered in that way, the next character will be selected automatically.
5. Once filled in, select the Enter symbol and confirm.
6. Repeat steps 4 and 5 for the Subnet mask and Default Gateway.
7. Select APPLY and click OK to confirm all changes.
When the connection is established, it is indicated with the connection symbol and the indication
Connected.

10.4 DMX

About the ways to control the projector via DMX
DMX signals can be connected to the DMX In port on the communicator interface when using a standard DMX
cable equipped with XLR connector. The DMX out can be used to create a chain of DMX devices. One
universe can control up to 512 channels.
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet
network can serve as the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple
universes are possible.
For a full list of all DMX channels, values and possible actions, see
About the DMX menu
DMX Feature What can be done?
DMX Mode Two different modes for DMX are available.
• Basic: A basic configuration where 2 channels are implemented.
• Extended: A full configuration, spread over 14 channels.
For the full mapping of each used channel, refer to the DMX chart in the appendices. See
"DMX chart", page
Start Channel Before a projector can execute DMX commands, a unique address (named DMX address
or Starting channel) should be given to the projector.
This address can vary from 1 to 512.
DMX Monitor If a DMX device is connected, the settings per channel can be displayed via the Monitor
button.
Reset for You can change the Shutter and intensity via DMX Channel 1 (both in Basic and Extended
Max intensity mode).
209.
GUI – System Settings
"DMX chart", page 209.
R5906112 /15 UDX 135