Table of Contents
Advertisement
Width, Projector 1
Picture frame
Projector 1
Image 8–61
From the start (mask) position, you can blend zone size per edge (left, top, right, bottom). For each edge there
will be a drop-off curve for the blend zone.
Waiting period and blend maintenance period
The heating and cooling down of the lens in a projector startup and shutdown cycle can have a minor drifting
effect on the blending and masking areas. Due to this, it is advised to wait 15– 20 minutes after projector
startup before performing blending and masking actions. This to make sure the drift on the blend region is as
minimal as possible. For a similar reason, it is advised to wait 15– 20 minutes after projector startup before
starting any blending maintenance in your existing setup.
It is recommended to perform a blend maintenance after every 10–20 startup-shutdown cycles of
the projector.
8.12.1 Basic blend
How to set up a basic blend zone?
1.
In the main menu, select Installation → Blend and Mask → Basic blend.
Image 8–62 Blend menu, Basic blend
The Basic blend menu is displayed.
Width, Projector 2
Picture frame
Projector 2
Overlap / Blend Zone
GUI – Installation
R5906112 /15
UDX
103
Advertisement
Table of Contents
