Table of Contents
Advertisement
11.2 Remote access – Enable camera preview
Camera preview
Up until Pulse software 2.0.x, you were able to see the footage of the camera when you remotely accessed
the projector. This was a feature you could disable using Projector Toolset.
However, from Pulse 2.1. x onward, this feature is disabled by default and can now be enabled in both
Projector Toolset and the Pulse GUI.
Upgrading your projector from a software version 2.0.x or older to 2.1.x or newer will disable
Camera preview by default. Once the software has been successfully upgraded, you can always opt
to enable this feature again.
How to enable Camera preview
1.
In the main menu, select Settings → Maintenance and login to visualize the hidden Remote access menu.
2.
Select Remote access.
Image 11–5 Maintenance menu, Remote access
The Remote access menu is displayed.
Image 11–6 Example of the Remote access menu
3.
Enable the slider to enable the Camera preview feature.
Image 11–7 Remote access menu, Camera preview is enabled
Advanced Settings
R5906112 /15
UDX
161
Advertisement
Table of Contents
