Table of Contents
Advertisement
GUI – Installation
Source signal
2D Source
Active Stereo source
Passive Stereo source
When a different Display Mode is chosen compared to the source signal (e.g. Active Stereo source
with Mono output), advanced image processing will make sure you a desirable image will be
displayed.
If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with the
IR communication between projector and the RCU. If such interference occurs, connect the RCU to
the projector using the remote cable. It is also advised to turn the IR receivers on the projector off to
avoid the 3D emitter interference. To turn off the IR receivers, see
button", page
How to adjust the projector to the 3D emitter?
1.
In the main menu, select Installation → 3D Setup.
Image 8–84 Installation menu, 3D setup
The 3D setup menu is displayed.
Image 8–85 Example of the 3D setup menu on a UDX
2.
If it is necessary to invert the stereo sync output, enable the Swap eyes option.
3.
If the projected moving 3D content doesn't look smooth enough, enable the Swap frame pair option to help
improve this.
4.
Select the desired the stereo Dark Time.
5.
Select the desired Display mode.
6.
Use the slider to set the desired stereo Sync delay.
116
R5906112 /15
UDX
AutoStereo
Output is a 2D image
Output is in Active Stereo Output is a 2D image
Output is in Active Stereo Output is a 2D image
33.
Mono
Output is a 2D image
"Pulse RCU, function of the on/off
ActiveStereo
Output is in Active Stereo
Output is in Active Stereo
Output is in Active Stereo
Advertisement
Table of Contents
