GUI – Projector profiles
9.1 Saving the current projector settings in a
profile
Which settings can be saved to a profile?
Profile domain
name
Illumination
Source
Image
Display (3D
settings)
Realcolor
TM
Warp
Blend
Black level
PQ (HDR)
Installation
Cooling
4
3.
only valid if recalled with same lens
4.
Only if external cooler is installed
118
R5906112 /15
UDX
Settings saved
•
Illumination power for each source
•
Light sensor enabled / disabled
•
Light sensor set point
Active source selection & EDID
•
Contrast
•
Brightness
•
Saturation
•
Sharpness
•
Gamma
•
Used gamma type
•
Digital zoom (width / height / factor + enabled/disabled)
•
Digital shift (x / y + enabled / disabled)
•
Output resolution
•
3D Display mode used
•
Swap eyes on / off
•
Swap frame pair on / off
•
Dark time and sync delay values
•
Brilliant Color mode (if available)
•
P7 desired values
•
P7 measured values
•
Warp status enabled / disabled
•
Screen size
•
Warp file selected (if available)
•
Transport delay
Note: Bow and 4 corners warp cannot be saved.
•
Blend mask enabled / disabled
•
All Masks (top / bottom / left / right) and heights (top / bottom / left / right)
•
Blend files enabled / disabled (if available)
•
Blend file selected (if available)
•
Black level file enabled / disabled
•
Black Level file selected (if available)
•
Basic black level enabled / disabled
•
Black level settings (top / bottom / left / right)
•
RGB gain values (Red, Green and Blue values)
•
Screen luminance (unit and value)
•
HDR Boost value
•
DynaBlack mode
•
Lens parameters (lens zoom, focus, shift and iris (if available))
•
Orientation (mounting & projection)
•
Scaling mode
•
Position of motorized frame (if used).
•
Shutter status (open or closed).
Selected Cooling mode
3