Controller Adjustments - Terex Genie GS-1530 Service Manual

Section 4 • Repair Procedures
PLATFORM CONTROLS
1-2

Controller Adjustments

Platform lift speed, stowed drive speed, raised
drive speed and high torque drive speed are
adjustable to compensate for wear in the hydraulic
pump and drive motors.
The function speeds are determined by the
percentage of total controller output.
For further information or assistance, consult the
Genie Industries Service Department.
Tip-over hazard. Do not adjust the
lift and/or drive speed higher than
specified in this procedure. Setting
the function speeds greater than
specifications could cause the
machine to tip over resulting in
death or serious injury.
Tip-over hazard. This procedure
must only be performed by a
trained service professional.
Attempting this procedure without
the necessary skills will result in
death or serious injury.
Note: Select a test area that is firm, level and free
of obstructions.
How to Determine the
Software Revision Level
1 Remove the platform controls from the platform.
2 Place the platform controls close to the
diagnostic display on the power unit side of the
machine.
3 Turn the key switch to platform control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
4 - 4
4 Press the lift function select button.
d
c
b
c
e
5 Slowly move the joystick in the direction
indicated by the yellow arrow.
Result: The software revision level will appear
in the diagnostic display.
Result: If the software revision level does not
appear in the diagnostic display, turn the key
switch to ground control and move the platform
lift switch in the down direction. The software
revision level will appear in the diagnostic
display.
6 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls and turn the key switch to the off
position.
GS-30 • GS-32 • GS-46
Stop
®
Gen 4 platform controller
a yellow arrow
b joystick controller JC1
c lift function select button BN9
d red Emergency Stop button P2
e platform controls diagnostic display
Gen 5 platform controller
Part No. 96316
June 2009
REV D
a
b
a
d