Hydraulic Specifications - Terex Genie GS-1530 Service Manual

June 2009
REV E

Hydraulic Specifications

Hydraulic Oil Specifications
Hydraulic oil type
ISO viscosity grade
Viscosity index
Cleanliness level, minimum
Water content, maximum
Chevron Rando HD oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and have a minimum viscosity index
of 150. They should provide excellent antiwear,
oxidation, corrosion inhibition, seal conditioning, and
foam and aeration suppression properties.
Optional fluids
Biodegradable
Fire resistant
Mineral based
Continued use of Chevron
Aviation A hydraulic fluid when
ambient temperatures are
consistently above 32°F / 0°C may
result in component damage.
Note: Use Chevron Aviation A hydraulic fluid
when ambient temperatures consistently below
0°F / -17°C.
Note: Use Shell Tellus T46 hydraulic oil when oil
temperatures consistently exceed 205°F / 96°C.
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult the Genie
Industries Service Department before use.
Part No. 96316
Chevron Rando HD equivalent
Multi-viscosity
15/13
200 ppm
Petro Canada Environ MV 46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydrolube HP-5046
Quintolubric 822
Shell Tellus T32
Shell Tellus T46
Chevron Aviation A
GS-30 • GS-32 • GS-46
Function pump
Type
Displacement per revolution
200
Flow rate @ 2500 psi / 172 bar
Hydraulic tank return filter
Function manifold
System relief valve pressure, maximum
Lift relief valve pressure
Steer relief valve pressure
Check valve manifold -
GS-1530, GS-1532, GS-1930, GS-1932
(after serial number GS3004-66986)
Check valve pressure, maximum
Continuous improvement of our products is a
Genie policy. Product specifications are
subject to change without notice.
Section 2 • Specifications
SPECIFICATIONS
Gear
0.244 cu in
4 cc
4 gpm
15 L/min
10 micron with
25 psi / 1.7 bar bypass
3500 psi
241 bar
1800 to 3500 psi
124 to 241 bar
1500 psi
103 bar
200 psi
13.8 bar
2 - 3