Scissor Assembly, Gs-3246 - Terex Genie GS-1530 Service Manual

October 2008
REV C
3-5
Scissor Assembly,
GS-3246
How to Disassemble the
Scissor Assembly,
GS-3246
Bodily injury hazard. The
procedures in this section require
specific repair skills, lifting
equipment and a suitable
workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications.
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Support and secure the entry ladder to an
appropriate lifting device.
3 Remove the fasteners from the entry ladder and
remove the entry ladder from the machine.
Crushing hazard. The entry ladder
may become unbalanced and fall
if not properly supported and
secured to the lifting device.
4 Remove the cables from the number 5 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Part No. 96316
5 Disconnect the number 5 cable bridge from the
number 5 outer arm (index #17) and remove
the cable bridge from the machine.
6 Remove the retaining fasteners from the
number 6 pivot pin (index #1).
7 Use a soft metal drift to remove the number 6
pivot pin (index #1). Remove the platform
mount bracket from the machine.
8 Attach a lifting strap from an overhead crane to
the number 5 outer arm at the ground control
side (index #17).
GS-30 • GS-32 • GS-46
Section 4 • Repair Procedures
SCISSOR COMPONENTS
GS-3246
Cable bridge legend
a cable bridge 5
b cable bridge 4A
c cable bridge 4B
d cable bridge 3A
e cable bridge 3B
f cable bridge 2A
g cable bridge 2B
h cable bridge 1
a
b
c
d
e
f
g
h
4 - 47