Steer Bellcrank - Terex Genie GS-1530 Service Manual

Section 4 • Repair Procedures
STEER AXLE COMPONENTS
8-3

Steer Bellcrank

How to Remove the Steer
Bellcrank
1 Remove the steer cylinder. See 8-2, How to
Remove the Steer Cylinder.
2 Remove the retaining fasteners from the steer
links at each end of the bellcrank.
Note: While removing the retaining fasteners, take
note of the quantity and location of the spacers
between the bellcrank and the steer links.
3 Center a lifting jack under the drive chassis at
the steer end.
4 Raise the machine approximately
14 inches / 36 cm. Place blocks under the
chassis for support.
Crushing hazard. The chassis
could fall if not properly supported.
5 Turn the yokes to the side so the bellcrank can
be removed.
6 Remove the bellcrank from the machine.
4 - 80
Note: While removing the bellcrank from the
machine, take note of the quantity and location of
the spacers between the bellcrank and the steer
links.
Note: Before re-installing the steer bellcrank onto
the machine, apply a small amount of Loctite onto
the threads of the fasteners. Torque the fasteners
to 31 ft-lbs / 42 Nm.
GS-30 • GS-32 • GS-46
June 2009
REV B
Part No. 96316