Scissor Assembly, Gs-3232 And Gs-3246 - Terex Genie GS-1532 Service And Repair Manual

March 2021
9-5
Scissor Assembly,
GS-3232 and GS-3246
How to Disassemble the Scissor
Assembly
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Machines equipped with a Platform Height
Sensor, begin the Scissor Disassembly procedure
at step 1. Machines without a Platform Height
Sensor, begin the Scissor Disassembly procedure
at step 24.
1 Turn the key switch to ground controls and
pull out the red Emergency Stop button to the
on position at both ground and platform
controls.
2 Raise the platform 7 to 8 feet / 2,1 to 2,4 m.
Part No. 1272217GT
3 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
4 Lower the platform onto the safety arm.
5 At the ground controls, turn the key switch to
the off position and push in the red
Emergency Stop button to the off position.
6 Disconnect the battery pack from the
machine.
7 Remove the fasteners securing the large
platform height sensor cover to the large
platform height sensor bracket.
8 Remove the platform height sensor cover.
9 Tag and disconnect the platform height
sensor from the platform height sensor
harness.
10 Remove the fastener securing the platform
height sensor assembly to the number 1 inner
arm.
11 Remove the platform height sensor assembly
from the number 1 pivot pin.
12 Remove the plastic nut securing the squeeze
connector to the large platform height sensor
bracket.
GS ™ -30 • 32 • 46 • 47
Service and Repair Manual
Scissor Components
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
107