Lexmark Optra S1625 User Manual page 201

Attendance
Message
35 Res Save Off
Deficient Memory
37 Insufficient
Collation Area
37 Insufficient
Defrag Memory
Meaning and Required Action
The printer lacks the memory needed to enable Resource Save. This
message usually indicates that too much memory is allocated for one
or more of the printer link buffers.
To enable Resource Save after this message displays, either install
additional memory or set each link buffer back to the Auto value.
Once all link buffers are set to Auto, exit the printer menus to activate
link buffer changes. When Ready displays, enable Resource Save in
the SETUP MENU and modify the link buffers again.
Press Go to clear the message. The printer automatically disables
Resource Save and continues.
The printer memory used to store pages of data is too full to collate
the rest of the print job.
• Press Go to clear the message. The printer collates the job in
segments.
• To cancel the current job, press Menu> or <Menu. The Job Menu is
displayed. Press Menu> or <Menu until Cancel Job is on the
second line. Press Select.
• To reset the printer, press Menu> or <Menu. The Job Menu is
displayed. Press Menu> or <Menu until Reset Printer is on the
second line. Press Select.
The printer memory used to store undeleted flash resources is too full
to perform the Flash Memory Defragment operation.
• Press Go to clear the message.
• To perform the defragment operation, you can:
- Delete fonts, macros and other data in printer RAM
- Install additional printer memory.
Caring for Your Printer
Understanding Printer Messages
185