Table of Contents
Advertisement
Chapter 4. T1 Network Interface
Remote Menu Access
Management Configuration
Unit Access Table
4-32
Displays Telnet menus for a remote device (may be another
TSU/TDU or any other ADTRAN product that supports
Telnet via its EIA-232 chain port). After selecting this option,
you may choose to connect to a device entered in the Unit
Access Table or enter a Unit ID for a unit not in the Unit
Access Table.
CTRL + X
the TSU 610 main menu.
This menu sets management information, such as SNMP
community names and trap destination addresses. See Figure
4-14.
This menu edits and creates the Unit Access Table. This table
stores the Unit ID, Passcode, and Unit Type for units
connected via chain ports or connected remotely to the TSU/
TDU (see Table 4-1 on page 4-34). An entry in the table is only
required to support proxy SNMP MIB access or polling. For
MIB access, an entry is required only if the unit's passcode is
not the same as the Default Unit Passcode or the unit is a
single port TSU Stand-alone.
It is not necessary to have an entry in this table for a remote unit in
order to Telnet to it or forward SNMP traps from it. In the Telnet
case, the Remote Menu Access menu is selected from the Main menu
and a Unit ID is entered which may or may not be in the Unit Access
Table.
terminates the session and returns to
TSU 610 User Manual
61200610L2-1
Advertisement
Table of Contents
