Editing The Temp Map; Applying The Temp Map; Reviewing Maps - ADTRAN TSU 610 User Manual

Step
1 Use
ter the Temp Map edit
mode.
2 Press the
cause the cursor to
move into the P
field.
3 Press the
Press the
4
61200610L2-1

Editing the Temp Map

If further changes to the Temp Map are needed, do the
following:
Action
to en-
selection 8
key to
Enter
ORT
key
ESC
key
Enter

Applying the Temp Map

Once the Temp Map reflects the desired configuration, use
or
selections 9 10
respectively.

Reviewing Maps

through
Selections 5
ports assigned to Map A, Map B, and the Temp Map,
respectively.
TSU 610 User Manual
Explanation
Upon entering this mode, the cur-
sor location moves to DS0 number
one in the DS0 field of the Temp
Map.
The cursor may be moved from one
DS0 to another by using the up and
down arrows until the cursor is lo-
cated at the DS0 number whose as-
signed port needs to be changed.
The up and down arrows are then
used to scroll through the possible
port selections.
This restores the previous port as-
signment and returns to the DS0
field.
This saves the current selected port
and returns to the DS0 field.
Once the cursor is again located in
the
Temp Map DS0
key a second time to return to
ESC
below the Temp Map
selection 1
display.
to apply this configuration to Map A or B,
give a summary of the number of
7
Chapter 4. T1 Network Interface
field, press the
4-19