Table of Contents
Advertisement
SNMP
61200610L2-1
T-Watch Pro/EIA-232 Connection
To set up the TSU 610 to work with T-Watch Pro over a direct
EIA-232 connection, the following steps are required:
Step
1
Set the U
NIT
mode.
See Unit ID on page 4-23 and Change/Set a Passcode on
page 4-22 for more details.
2
Set the C
ONTROL
PC Com port.
3
Connect the PC C
the TSU 610 using the DB25 to modular adapter and
6-foot modular cable.
Follow the installation instructions for T-Watch Pro to
4
start the program and connect to the unit.
The ADTRAN TSU 610 supports the Simple Network
Management Protocol (SNMP) through the chain-in (SLIP)
interface. See Appendix B, Understanding SNMP for detailed
information.
To use SNMP with the TSU 610, do the following:
Step
1
Set CONTROL PORT to SLIP for Chain-In Port.
2
Load the appropriate MIB browser into the Network
Management Station.
This is available on the ADTRAN webpage at
http://www.adtran.com).
The MIB browser issues SNMP gets/sets to the TSU
610.
TSU 610 User Manual
Action
ID and the P
ASSCODE
P
to the same setting as the
ORT RATE
to the C
OM PORT
Action
Chapter 3. Operation
using the terminal
-I
on
HAIN
N PORT
3-11
Advertisement
Table of Contents
