Initialization
61200610L2-1
Set User Passcode
The TSU 610 is designed to operate with or without the use of
a passcode. The default condition is without a passcode.
If the unit is to be remotely accessed using T-Watch Pro, you must
enter a passcode. When managing a number of units, the passcode
can be the same for all the units.
The passcode should be a number easily remembered. Once
entered, the passcode is required to access any operation
other than viewing. See Set Passcode on page 4-22.
Set Unit Identification
The Unit ID sets the unit to respond to remote control
(controlled by a device other than the front panel or
terminal). If no Unit ID is recorded it is not possible to
operate from any remote control device, including the local
PC for T-Watch Pro or SNMP. See Unit ID on page 4-23 for
details.
Set Control Port
The TSU 610 can be configured from the control port when
T-Watch Pro, SNMP, or the terminal interface is being used.
If the control port is to be used, the control port baud rate
must also be selected.
Chain-In (PC)
The unit can be controlled from an external PC connected
directly or via modem to the Chain-In port. When using
Chain-In, the selection of the control port baud rate from 9600
(factory default), 1200, 2400, or 4800, 19200, or 38400 must be
made using the Unit Configuration menu. Unless locked out
externally, the front panel can also control the unit.
Chain In/Chain Out
TSU 610 units and other TSUs can be linked together to form
a chain. Figure 2-7 provides an example of a chain-in
arrangement with a PC or a modem. The first TSU 610 in the
chain receives controlling input from the PC or modem.
TSU 610 User Manual
Chapter 2. Installation
2-11