Ventilation Clearance; Table 2-1. Ventilation Clearance - Teledyne T400 User Manual

With no power to the unit, carefully remove the top cover of the instrument and check for
internal shipping damage by carrying out the following steps:
1. Carefully remove the top cover and check for internal shipping damage.
2. Inspect instrument interior to ensure all circuit boards and other
3. Check the connectors of the various internal wiring harnesses and
4. Verify that all of the optional hardware ordered with the unit has been
2.1.1 V
ENTILATION
Whether the analyzer is set up on a bench or installed into an instrument rack, be sure to
leave sufficient ventilation clearance.

Table 2-1. Ventilation Clearance

Back of the instrument
Sides of the instrument
Above and below the instrument
Various rack mount kits are available for this analyzer.
information.
20
a. Remove the screws located on the instrument's sides.
b. Slide cover backward until it clears the instrument's front bezel.
c. Lift cover straight up.
components are intact and securely seated.
pneumatic hoses to ensure they are firmly and securely seated.
installed. These are listed on the paperwork accompanying the instrument.
WARNING – ELECTRICAL SHOCK HAZARD
Never disconnect PCAs, wiring harnesses or electronic
subassemblies while under power.
C
LEARANCE
AREA
Teledyne API – Model T400 O
MINIMUM REQUIRED CLEARANCE
10 cm / 4 in
2.5 cm / 1 in
2.5 cm / 1 in
Contact Sales for more
Analyzer 083730400A DCN8130
3