Specifications; Table 1-1. T400 Basic Unit Specifications - Teledyne T400 User Manual

1.1

SPECIFICATIONS

Table 1-1. T400 Basic Unit Specifications

PARAMETER
Ranges
Measurement Units
Zero Noise
Span Noise
Lower Detectable Limit
Zero Drift
Span Drift
Lag Time
Rise/Fall Time
Linearity
Precision
Sample Flow Rate
Power Requirements
Analog Output Ranges
Recorder Offset
Standard I/O
Optional I/O
Operating Temperature Range
Humidity Range
Pressure Range
Temp Coefficient
Voltage Coefficient
Dimensions (H x W x D)
Weight
Environmental Conditions
083730400A DCN8130
Min: 0-100 ppb Full scale
Max: 0-10 ppm Full scale (selectable, dual ranges and auto-ranging supported)
ppb, ppm, µg/m 3 , mg/m 3 (selectable)
< 0.2 ppb (RMS) (with 80 Sample Digital Filter)
< 0.5% of reading (RMS) above 100 ppb
< 0.4 ppb (with 80 Sample Digital Filter)
< 1.0 ppb/24 hours
< 1% of reading/24 hours
< 10 sec
< 20 sec to 95%
1% of full scale
< 0.5% of reading above 100 ppb
800 cc/min ±10%
Rating
110 - 120 V~ 60 Hz 3.0 A
220 - 240 V~ 50 Hz 3.0 A
220 - 240 V~ 60 Hz 3.0 A
10V, 5V, 1V, 0.1V (selectable)
±10%
1 Ethernet: 10/100Base-T
2 RS-232 (300 – 115,200 baud)
2 USB device ports
8 opto-isolated digital outputs
6 opto-isolated digital inputs (3 defined, 3 spare)
4 analog outputs
1 USB com port
1 RS485
4 digital alarm outputs
Multidrop RS232
3 4-20mA current outputs
5 - 40°C (with EPA Equivalency)
0-90% RH, Non-Condensing
25 – 31 "Hg-A
< 0.05% per deg C
< 0.05% per Volt AC (RMS) over range of nominal ± 10%
7" x 17" x 23.5" (178 x 432 x 597 mm)
28 lbs (12.7 kg)
30.6lbs. (13.8kg) with IZS Option
Installation Category (Over voltage Category) II Pollution Degree 2
Intended for indoor use only at altitudes ≤ 2000m
Teledyne API – Model T400 O
SPECIFICATION
Typical Power Consumption
110 W
112 W
112 W
Analyzer
3
17