S Numeral Memory Table Write Command - Omron NT620S Operation Manual

Commands/Responses
Numeral memory table write command
Command
Format
[ESC] W
1B 57
Data of 1 word
d1
1
* *
Response
Format
Function
N m t t
1 2
E * * * *
d1 , dn
m
* * 2C * *
m
t to t
1 4
I , I
1 2
d1 to d1 , ..., dn
1 m
s , s
1 2
Only if "Yes" is set for the "Response" memory switch, the response indicated
below is returned on normal completion.
[ESC] W
1B 57
s , s
1 2
S Writes the data of the specified number of numeral memory tables, starting
from the specified numeral memory table.
S Writing from a maximum of 20 memory tables is possible at one time.
t t (l )
3 4 1
* * * * * *
Data of 1 word
dn (s )
1 m 1
* * * *
: Check sum present/absent (1 BCD digit)
0 : Absent
1 : Present
8 : Absent (only 1 table written)
9 : Present (only 1 table written)
: First numeral memory table number written to
(4 BCD digits)
0000 to 0999
: Number of written tables (2 BCD digits)
01 to 20 : 1 to 20 tables
When m is 8 or 9, omit this setting.
to dn :
1 m
Contents of the numeral memory tables
(1 to 8 hexadecimal digits)
0 to FFFFFFFF
It is possible to omit initial zeroes so that there are less
than 8 digits.
Individual words of data are delimited by commas.
: Check sum (2 hexadecimal digits)
When m is 0 or 8, omit this setting.
N 0 0
4E 30 30
: Check sum (2 hexadecimal digits)
This is always added (fixed as "20").
Section 6-3
(Sent from host to PT)
(l )
2
* *
(s ) [CR]
2
* * 0D
s s [CR]
1 2
32 30 0D
255