Omron NT620S Operation Manual page 165

Touch Switches
Touch Switch Attributes
Touch Switch area
Display frame
Display frame
Touch Switch area
The following attributes can be set for the Touch Switches.
• Display frame
A display frame of the Touch Switch can be specified by the following two meth-
ods.
- Fixed-shape display frame
This is a frame displaying an area of display frame type that acts as Touch
Switch. There are four kinds of display frames as shown in the Table below:
"Standard", "Solid 1", "Solid 2", "No Display Frame" ("Solid 2" is only available
with the NT620C).
When "No Display Frame" is selected, only the label is displayed (or nothing
if no label is specified) unless an ON (or flash) instruction is sent from the PC,
or the touch switch is pressed.
Display Frame Type
Standard
Solid 1
Solid 2
No display frame
- Free-shape display frame
This is a display frame capable of freely setting the display position and
shape irrespective of Touch Switch area. A shape to be specified can be se-
lected out of "Square", "Circle", "Polygon", and "Fan".
For example, free-shape display frame can be used in the following manner.
When this position
is pressed
<Example of setting a display frame inside the Touch Switch area>
When this position
is pressed
Switch OFF Switch ON
Shown in reverse video
Shown in reverse video
É É É
É É É
É É É
Section 4-7
153