Ejecting A Magazine From Cas; Figure 1.12 Magazine Ejection Method - Fujitsu ETERNUS LT160 User Manual

1.1.4.2 Ejecting a magazine from CAS

1) After the CAS external door is unlocked with an operation from the operator panel,
2) Hold the handle on the rear side of the magazine inside CAS, lift the handle by
3) Pull the magazine out completely from CAS by pulling the handle still further.
C144-E072-01EN
the external door opens slightly. By hand, gently open the external door to the left
until you hear a click.
holding it so that the magazine front is pointing downward and the bottom on the rear
side is lifted (Figure 1.12). In this state, pull the handle out from the device.

Figure 1.12 Magazine ejection method

1.1 Device Configuration
1-15