2) Set the item of "Auto Cleaning."
3) Click the [OK] button after all settings are completed. To restore the conditions
4) After clicking the [OK] button, the system displays a confirmation window showing
5) A window displaying the processing results is displayed. This completes the
5.5.3
Setting information about the network
The following explains how to set network information.
From the network information setting window, the IP address, subnet mask, gateway, and
device name can be set.
1) Click the [Network] button displayed under [Setup] in the menu frame. The network
C144-E072-01EN
-
Enable: Perform auto cleaning.
-
Disable: Do not perform auto cleaning.
before the settings, click the [Reset] button.
the input contents.
Click the [OK] button if it is OK to proceed. To make entries again, click the [Back]
button.
settings.
setting window will be displayed.
If the network settings are already made, its values are displayed.
Figure 5.26 Network information setting window
5.5 Setting Library Information
5-35