Setting The Target Id Of The Drive - Fujitsu ETERNUS LT160 User Manual

4.4

Setting the Target ID of the Drive

1) First, select the [Drive] button from the SETUP menu.
2) Then, specify the drive number.
3) Select the Addressing mode (*1).
4) If "Hard Address" is set, specify the LOOP ID.
C144-E072-01EN
Figure 4.19 Selecting the [Drive] button
SETUP menu
-Drive
+DRV#00
+DRV#01
To specify the LOOP ID directly, select the [Hard Address] button.
SETUP menu
-Drive
-DRV#00
+Hard address
To specify the LOOP ID automatically, select the [Soft Address] button.
SETUP menu
-Drive
-DRV#00
+Soft Address
"Soft Address" is set by default.
4.4 Setting the Target ID of the Drive
Remarks:
4-25