Model A32 Specification (Drive: 1 To 16 Units Installed - Fujitsu ETERNUS LT160 User Manual

Technical Specifications
Component for hot swap
Robot controller
Number of transport robots
Input voltage
Number of phases
Power frequency
AC input system
Power consumption (max)
Other interfaces
*1: To increase the number of cartridge volumes to be stored to 182 or 221, add separate
*2: Two magazines for holding cartridges are supplied with the library.
*3: The capacity value is calculated by assuming that 1 Tbyte = 1000
*4: The performance of data transfer speed depends on the data compression rate and
*5: The mass is the value with the maximum configuration for each model.
*6: The number of PDUs to be installed depends on the number of drives that will be
B.1.2

Model A32 specification (drive: 1 to 16 units installed)

Number of cabinets
Number of stored cartridge
volumes (*1)
Tape drive
Installed tape drive
Applicable cartridge media
Cartridge
insertion
mechanism
(*2)
Storage capacity (*3) (max/non-
compressed)
Data transfer speed
* When non-
B-2
Item
cell options.
tape block size.
installed.
Table B.2 Model A32 specification
Item
Number of
installed drives
Number of
cartridges
Number of
mechanisms/
device
GB/h
(MB/sec)
compressed
(*4)
Specification
Tape drive/cooling fan
1 unit
1 unit
100-240V AC
Single phase (with FG)
50-60Hz
1 - 2 (*6)
1.3KW
10Base-T/100Base-TX
Specification
1
89 volumes
1 - 16 units
LTO Ultrium 1 tape drive
LTO Ultrium 1 tape cartridge
5 volumes/magazine
2 units
8.9 TB
54 - 864
(15 - 240)
4
bytes
167 volumes
16.7 TB
C144-E072-01EN