Viewing Waveform Segment Markers - Agilent Technologies E8257D PSG User Manual

Basic Digital Operation
Using Waveform Markers
NOTE Most of the procedures in this section begin at the

Viewing Waveform Segment Markers

Markers are applied to waveform segments. Use the following steps to view the markers set for a
segment (this example uses the factory–supplied segment, SINE_TEST_WFM).
1. In the Marker Utilities menu
2. Highlight the desired waveform segment.
In an ARB format, there is only one file (AUTOGEN_WAVEFORM) and it is already highlighted.
3. Press
Display Markers
Experiment with the Zoom functions to see how they display the markers.
The display can show a maximum of 460 points; displayed waveforms with a sample point range
greater than 460 points may not show the marker locations.
102
(page 101), press
> . The maximum zoom in range is 28 points.
Zoom in Max
When using an ARB format other than
Dual ARB, you must turn on the format
to enable the Set Markers softkey.
Marker Utilities
.
Set Markers
softkey menu.
Chapter 3