Agilent Technologies E8257D PSG User Manual page 68

Basic Operation
Configuring the RF Output
Figure 2-6
6. Press
Turn Off Markers
All active markers turn off. Refer to the Agilent PSG Signal Generators Key Reference for
information on other marker softkey functions.
Adjusting Sweep Time
1. Press .
Sweep/List
This opens a menu of sweep control softkeys and displays a status screen summarizing all the
current sweep settings.
2. Press
Configure Ramp/Step Sweep
Since ramp is the current sweep type, softkeys in this menu specifically control ramp sweep
settings. When step is the selected sweep type, the softkeys control step sweep settings. Notice
that the and
Freq Start
menu.
3. Press to Manual >
Sweep Time
In auto mode, the sweep time automatically sets to the fastest allowable value. In manual mode,
you can select any sweep time slower than the fastest allowable. The fastest allowable sweep time
is dependent on the number of trace points and channels being used on the 8757D and the
frequency span.
54
Delta Markers on 8757D
.
.
softkeys appear in this menu in addition to the
Freq Stop
> .
5 sec
hardkey
Frequency
Chapter 2