Agilent Technologies E8257D PSG User Manual page 69

4. Press to Auto.
Sweep Time
The sweep time returns to its fastest allowable setting.
NOTE When using an 8757D network analyzer in manual sweep mode, you must activate the signal
generator's Manual Mode before using the
>
Sweep/List More (2 of 3) > Manual Mode On.
Using Alternate Sweep
1. Press the hardkey.
Save
This opens the table editor and softkey menu for saving instrument states. Notice that the
softkey is active. (For more information on saving instrument states refer to
Reg
Instrument State Registers" on page
2. Turn the front panel knob until you find an available register and press
saved register number. If no registers are available, you can write over an in–use register, by
pressing .
Re–SAVE
NOTE
When you are using the PSG in a system with an 8757D network analyzer, you are limited to
using registers 1 through 9 in sequence 0 for saving and recalling states.
3. Press >
Sweep/List Configure Ramp/Step Sweep
ramp sweep.
4. Press
Alternate Sweep Register
previously saved sweep state.
5. Press
Alternate Sweep Off On
The signal generator alternates between the original saved sweep and the current sweep. You may
need to adjust 8757D settings to effectively view both sweeps, such as setting channel 2 to
measure sensor A. Refer to
Chapter 2
63.)
and enter new start and stop frequency values for the
and turn the front panel knob to select the register number of the
to On.
Figure 2- 7.
softkey to control the sweep. Press
Manual Freq
Basic Operation
Configuring the RF Output
Select
"Using the
. Remember this
SAVE
55