Table of Contents
Advertisement
Two–Tone Waveform Generator
Creating, Viewing, and Modifying Two–Tone Waveforms
1. On the signal generator, press
2. Press
to regenerate the waveform.
Apply Settings
NOTE
Whenever a change is made to a setting while the two–tone generator is operating (
set to On), you must apply the change by pressing the
On
updated waveform will be generated. When you apply a change, the baseband generator
creates a two–tone waveform using the new settings and replaces the existing waveform in
ARB memory.
3. On the spectrum analyzer, temporarily turn off waveform averaging to refresh your view more
quickly. You should now see a left–aligned two–tone waveform that is similar to the one shown in
Figure 10-
5.
Figure 10-5
Two–Tone
Channels
Intermodulation
Distortion
236
>
Mode Setup
Alignment Left Cent Right
Carrier
Frequency
to Left.
softkey before the
Apply Settings
Upper Tone
Aligned with
Carrier
Frequency
Two Tone Off
Chapter 10
Hide quick links:
Advertisement
Table of Contents
