Agilent Technologies E8257D PSG User Manual page 155

NOTE For operating information on your particular power meter/sensor, refer to their operating
guides.
Connect the Equipment
CAUTION
To prevent damage to the signal generator, turn off the line power to the signal
generator before connecting the source module interface cable to the rear panel SOURCE
MODULE interface connector.
Option 521 signal generators can damage MM source modules. Consult the MM source
module's operating manual for input damage levels.
1. Turn off the line power to the signal generator.
2. Connect the equipment. For standard signal generators, use the setup in
generators with Options 1EA, 1EU, or 521, use
NOTE
During the process of creating the user flatness correction array, the power meter is slaved
to the signal generator via GPIB. No other controllers are allowed on the GPIB interface.
Chapter 4
Creating and Applying User Flatness Correction
Figure 4- 6.
Optimizing Performance
Figure 4- 5. For signal
141