Table of Contents
Advertisement
Before You Begin
[52]
Step
1.
2.
3.
4.
5.
Apply the Grease to the Driver Bar
[53]
Step
1
2
3
4
Action
Trim the first part from the nozzle.
Remove the cap from the tube of grease.
Fit the nozzle to the tube of grease.
On the user interface, touch
ADVANCED > STITCHER UP >
STITCHER UP
Lift the BLM500 main deck
Action
Use the supplied air duster to
remove dust from the stitch head.
Remove the wire holder from the
stitch head.
Apply a small amount of grease
to the visible surface of the driver
bar
Re-fit the wire holder.
Lubricate the Stitch Head
Information
figure 44 on page 85
The folder cover must be
closed. This action moves the
stitch head to the correct
position for lubrication.
See Lift the Océ BLM500 Main
Deck
on page 40
Information
Move the wire holder retaining spring
to the right. Then remove the wire
holderIntroduction
on page 85
figure 46 on page 86
[47]
30mm
[48]
87
Advertisement
Table of Contents
