Table of Contents
Advertisement
Error Messages
[27]
Problem
AXES MOVING
BOOK CYCLE TIME
TOO LONG
Bridge axis moving
BRIDGE INFEED
COVER OPEN
BRIDGE MOTOR
STALL
CHECK THE TRIM
BIN
COVER OPEN
DRIVE MOTOR
STALL
Endlay axis moving
Cause
Some of the machine axes are
moving. This message clears
when the adjustment is
complete.
The printer has delivered the sets
faster than the books can be
made. To decrease the book
cycle time, adjust the machine
settings:
decrease the number of
FORMS
decrease the number of
STITCHES
decrease the TAMPER
TIME
The bridge axis is moving. This
message clears when the
adjustment is complete.
The bridge infeed cover is open.
The machine will not operate
until the cover is closed.
Check for a paper jam in the
connecting bridge. Clear the jam
and continue.
The trim bin is either open or
full. Check the trim bin. Empty
the trim bin if necessary.
A safety cover is open. The
machine will not operate until
the cover is closed.
There is a paper jam. Check the
machine and correct the error.
The endlay axis (size
adjustment) is moving. This
message clears when the
adjustment is complete.
Error Messages
Solution
(see 'Clear Paper
Jams' on page
60)
(see 'Clear Paper
Jams' on page
60)
51
Advertisement
Table of Contents
