Table of Contents
Advertisement
The CONFIGURE Window
Introduction
The CONFIGURE
machine.
Some of the settings can be changed, depending on the current access level.
CONFIGURE Window Buttons
[13]
[13] Button overview
Button
MACHINE
OPTIONS
- MEASUREMENT
- STITCH SENSOR
- PRESET PAPER
SIZES
NETWORK
SETTINGS
SHUTTLE
-TAMPER DELAY
- TAMPER TIME
FORM
window lets you make changes to the configuration of the
Information
Touch MACHINE OPTIONS to view the general
machine setup. Some of the settings can be changed,
depending on the current access level.
Select 'mm' or 'inch' as the unit of measurement.
There is a sensor that checks for stitches. Touch STITCH
SENSOR to turn the stitch sensor on or off. The default
setting is ON.
The preset paper sizes can be either ISO A sizes or US
paper sizes. To select which preset paper sizes are
available, touch the relevant button.
This button is used by the service engineer.
Touch SHUTTLE to make adjustments to the tamper
and pickup.
The tamper removes air from the set before the set moves
to the stitch area.
Touch TAMPER DELAY to increase or decrease the
delay before the tamper is activated. Light weight paper
may need more time to stabilize.
An increase in TAMPER DELAY causes a decrease in
the production rate for thin books.
The default setting is 400.
TAMPER TIME adjusts the time that the tamper
touches the set. The default setting is 600.
This button is used by the service engineer.
The CONFIGURE Window
31
Advertisement
Table of Contents
