Table of Contents
Advertisement
Clear a Stitch Wire Jam
Before You Begin
[39]
Step
1
2
3
Clear the Jammed Wire
[40]
Step
1
2
3
4
5
68
Chapter 5 Error Conditions, Problems and Solutions
Action
Turn off the BLM500
Disconnect the BLM500 from the
mains power supply.
Lift the BLM500 main deck
Action
Cut the stitch wire at position
'A' approximately 50mm
(2-inches) from where the
stitch wire leaves the
stitch-wire guide.
Cut the stitch wire at position
'B' between the feed gears
and the middle wire tube.
Pull the stitch wire from the
stitch wire guide block.
Pull the stitch wire from the
middle wire tube.
Install the stitch wire into the
stitch head.
Information
Use the mains ON/OFF switch.
(see 'Lift the Océ BLM500 Main
Deck' on page
40)
Information
[32]
A
Detail A: Cut stitch wire here.
[33]
B
Detail B: Cut stitch wire here.
[34]
Pull stitch wire in direction of arrow
Stitch Head.. If there is not enough
stitch-wire left to pull, then follow the
procedure(see 'Remove the Stitch
Wire from the Stitch Head' on
page
91)
(see 'Install the Stitch Wire into the
Stitch Head' on page
93)
Advertisement
Table of Contents
