Adjust The Gate In The Gathering Area - Oce BLM500 User Manual

Adjust the Gate in the Gathering Area

Adjust the Gate in the Gathering Area
Introduction
The gate in the gathering area must be in the 'up' position for jobs of 1 to 3 sheets
and in the 'down' position for jobs of more than 3 sheets. If the gate is left 'down' for
thin jobs, then the sheets of paper can be damaged or jam in the machine.
[20]
[20] Gate in the 'up' position
[25]
A
B
C
When to do
When you start a new job
Lift the Gate in the Gathering Area
Open the gathering area cover. Open the Gathering Area Cover
1.
Lift the gate on the sidelay until the gate engages with the metal
2.
Close the gathering area.
3.
Lower the Gate in the gathering Area
Open the gathering area cover. Open the Gathering Area Cover
1.
Press on the gate to disengage the gate from the metal
2.
Close the gathering area.
3.
44 Chapter 4 Standard Tasks
Metal Spring Clip
Gate
Sidelay
A
B
C
spring-clip.figure 20
on page 39.
spring-clip.figure 20
on page 39