[43]
Step
Action
1
"Lift the Océ BLM500
main deck.
2
Remove the wire-holder
from the stitch head.
3
Inspect the area behind the
wire-holder for
stitch-wire.
4
Remove any stitches or
pieces of stitch-wire and
clean the area with the
air-duster.
5
Lubricate the stitch-head.
6
Fit the wire-holder.
7
Close the Océ BLM500.
8
Start the Océ BLM500.
Clear a Stitch Head Jam
Information
Lift the Océ BLM500 Main Deck
page 40
Move the wire-holder retaining
spring to the right.
page 69
Remove the wire-holder
If the wire-holder is held in position, use
a screw driver to help remove the
wire-holder from the stitch head.
[37]
figure 36 on page 70
Use the wire-cutters to remove any
jammed stitches or pieces of stitch-wire.
Lubricate the Stitch Head
Remember to put the wire-holder
retaining spring in position.
If the head operates normally and returns
to the parked position, then further action
is not needed.
If the stitch-head remains jammed, then
repeat the procedure once.
If the problem continues, then contact
your service engineer.
on
figure 35 on
on page 85
71