Oce BLM500 User Manual page 54

Error Messages
Problem
MOTOR
OVERLOAD
REMOVE SET
FROM FOLD AREA
REMOVE SET -
GATHERING AREA
Rotate axis moving
Shuttle axis moving
SHUTTLE MOTOR
COMMS FAIL
SHUTTLE MOTOR
ERROR
SHUTTLE NOT
PARKED
Sidelay axis moving
STACKER FULL
Stitch axis moving
54 Chapter 5 Error Conditions, Problems and Solutions
Cause
The drive motor controller has
reached its power limit. Check
for a paper jam and clear if
necessary. If the problem
continues, contact your service
engineer.
Open the folder cover and
remove the set.
Open the gathering area and
remove the sheets. Or touch
'PURGE SET'.
The rotate axis is moving. This
message clears when the
adjustment is complete.
The shuttle axis is moving. This
message clears when the
adjustment is complete.
Use the mains ON/OFF switch.
Turn the machine OFF, then turn
the machine ON. If the problem
continues, then call your service
engineer.
Use the mains ON/OFF switch.
Turn the machine OFF, then turn
the machine ON. If the problem
continues, then call your service
engineer.
The shuttle is in the wrong
position. Touch START
reset the position.
The sidelay axis (size
adjustment) is adjusting. This
message clears when the
adjustment is complete.
The stacker is full. Unload the
books from the stacker.
The stitch axis is moving. This
message clears when the
adjustment is complete.
Solution
to