Table of Contents
Advertisement
GS4000 Installation Guide Revision 4.00
1.3.3
POW-HSDCE
This is the DC-48/60V power supply used for GS4000-80E2.
(1) Outer Appearance
As for the LED, see Table 1.3-3.
Mounting Screw
Handle
Potential Tap
(Read the
Warning below.)
Figure 1.3-3
(2) LEDs
In the DC-48/60V power supply for GS4000-80E2, the action status is indicated by the
combination of the two LEDs as shown in Table 1.3-3.
Table 1.3-3
Name
POWER
ALARM
（LED = Green）
（LED = Red）
Power ON
Power OFF
Power OFF
Power ON
Power OFF
Power OFF
Note: There is the possibility that both POWER LED and ALARM LED are powered off depending on the type of trouble.
(3) Accessories
No accessories provided.
*
1-36
LEDs
Cable Clamp
Outer Appearance of POW-HSDCE
WARNING: TO MEASURE THE VOLTAGE AT A DC-POWERED DEVICE, THE END
TERMINAL IS ATTACHED TO POW-HSDCE. ONLY TRAINED ENGINEERS OR
MAINTENANCE SERVICE PERSONELL ARE ALLOWED TO MEASURE THE
VOLTAGE. TO AVOID A FIRE OR AN ELECTRIC SHOCK, DO NOT INSERT
SMALL PINS OR PAPER CLIPS INTO THE TERMINAL.
LED Indications on the POW-HSDCE Front Panel
Action Status
Output voltage is normal.
Output voltage is abnormal.
Power is OFF or the output voltage is abnormal.（Note）
NOTE: DC cables must be prepared by the customers themselves.
Terminal
Terminal
Board Cover
Board
Circuit
Breaker
520-10-026-30X
Advertisement
Table of Contents
