Table of Contents
Advertisement
GS4000 Installation Guide Revision 4.00
4.10
CONNECTING A SETUP TERMINAL TO THE GS4000
(1) Connecting a Setup or an Operation Terminal to the CONSOLE Port of a GS4000
When connecting a setup (or an operation) terminal to the CONSOLE port of GS4000, this
should be done with the RS-232C cross cable (with D-SUB9 pins on both ends (female)).
RS-232C Cross Cable with D-Sub
9 Pins (Female) On Both Ends)
Figure 4.10-1 Setup (or Operation) Terminal Connected to the GS4000
Step 1
Connect the RS-232C cross cable to the GS4000 by inserting it into the CONSOLE
port of the GS4000, and then screw up the cable firmly to mount its position.
D-Sub 9-Pin Connector
Figure 4.10-2 RS-232C Cross Cable Being Connected
Step 2
Likewise, connect the RS-232C cross cable to a setup terminal in the same manner
as above.
4-38
Setup or Operation Terminal
BCU
CONSOLE Port
CONSOLE Port
Screws
520-10-026-30X
Advertisement
Table of Contents
