Hitachi GS4000 Series Installation Manual page 34

GS4000 Installation Guide Revision 4.00
Table 1.1-8
Name Color
FAN0
Green/Red
FAN1
BCU0
Green/Yellow/Red
BCU1
PSU0 (NIF1/0)
PSU1 (NIF3/2)
Green/Yellow/
Red
PSU2 (NIF5/4)
PSU3 (NIF7/6)
NOTE 1: When a high port-density PSU-integrated NIF is installed, its action status is shown here.
NOTE 2: When a high port-density PSU-integrated NIF is installed, and even though the LED status is "Green(blinking)",
the NIF will not be active in the following cases:
・
During a time span of approximately 10 seconds after the LED status becomes "Green(ON)" after GS4000 is powered on.
・
The "close nif" command is entered from an operation terminal.
・
The "disable" configuration command is entered from an operation terminal.
NOTE 3: For a high port-density PSU-integrated NIF, the "OFF" status of LED means that exchanging the NIF is possible.
*
1-16
LED Indicators on the GS4000-160E1 Chassis
Role
Shows the action status
of FAN0.
Shows the action status
of FAN1.
Shows the action status
of BCU0.
Shows the action status
of BCU1.
Shows the action status
of PSU0(NOTE1)
Shows the action status
of PSU1(NOTE1)
Shows the action status
of PSU2(NOTE1)
Shows the action status
of PSU3(NOTE1)
NOTE: Regarding the "close nif" command, see the manual " GS4000・GS3000 Software
manual, Operations Commands". As for the "disable" information, see the manual "
GS4000・GS3000 Software manual, Configuration Commands CLI -CLI Type 1
Hierarchical Input Format, Vol. 2.
Action Status
Green (ON): running in normal condition
Red (ON): failure detected
Green (ON): operation possible
Yellow (ON): locked out
Green (blinking): in preparation for startup
Red (ON): failure detected
OFF: BCU powered off（BCU exchangeable）
Green (ON): operation possible(NOTE2)
Green (blinking): in preparation for startup
Yellow (ON): locked out
Red (ON): failure detected
OFF: PSU powered off（PSU exchangeable(NOTE3)）
520-10-026-30X