Table of Contents
Advertisement
GS4000 Installation Guide Revision 4.00
Step 4
Remove a network interface board by pulling it toward you. (Pull out a network
interface board just a little bit toward you by holding the areas shadowed with
remove it completely by holding its side panels.)
Procedure 1.
Pull out the NIF just a little bit
Figure 5.7-4
!
5-50
toward you by holding here
Network Interface Board Removed From the Device
Caution: Whenever you use GS4000 without mounting its option modules into it ,
attach the blank panels to it. Otherwise, air flows for the device cannot be
secured and the temperature inside the device heats up, causing troubles in
it.
Procedure 2.
Remove the NIF completely
by holding here
, then
520-10-026-30X
Advertisement
Table of Contents
