Table of Contents
Advertisement
Step 2
Insert the Basic Control Unit into the slot until it reaches the position indicated in
the figure below, and then fold its levers to the indicated direction. (The basic control unit will
be inserted into the slot completely.)
Lever
Figure 5.5-5
*
Step 3
Fasten the screws of the basic control unit.
!
520-10-026-30X
Basic Control Unit Being Locked In Place
NOTE: When inserting a basic control unit into the slot, do it holding its levers so that
its connector part is fixed into its position correctly. When moving levers, do it
slowly without giving much pressure to them.
Caution: Use a driver when attaching a basic control unit, and make sure that it is fixed
into its position firmly.
GS4000 Installation Guide Revision 4.00
Lever
5-41
Advertisement
Table of Contents
