Table of Contents
Advertisement
3.2.10 10GBASE-LR single-mode
optic fiber cable (core diameter 10 μm)
3.2.11 OC-192c POS single-mode
optic fiber cable (core diameter 10 μm)
3.2.12 OC-48c POS single-mode
optic fiber cable (core diameter 10 μm)
3.2.13 10BASE-T/100BASE-TX/1000BASE-T
interface cable (CAT.5E)
3.2.14 10BASE-T/100BASE-TX
interface cable (CAT.5)
Setup terminal or operation terminal
Operation terminal
Modems, etc.
Figure 3.1-1
3.2
INTERFACE CABLE SPECIFICATIONS
This section provides the specific information about the interface cables used for GS4000.
*
520-10-026-30X
3.3.2 (1) RS-232C cross cable
3.3.2 (2)10BASE-T/100BASE-TX
interface cable (CAT.5
3.3.2 (3) RS-232C straight cable
Customer's Responsibility
GS4000 Connecting Cable Distribution Diagram (2/2)
NOTE: Prepare an optic fiber cable with the additional length (3m) included, which is
necessary for the maintenance. Carefully bundle the excess Cable and place it
near the device. Also, do not put excessive pressure on optic fiber cables in
case that they are mingled with other interface cables.
NOTE: Prepare several optic fiber cables as spares and keep them available for use.
GS4000 Installation Guide Revision 4.00
NE10G-1RX
S22-10G4RX
(XFP-LR)
NP192-1S
NP192-1S4
NP48-4S
(SFP-P48SR)
(SFP-P48LR)
NE1000－12T
NE1G-12TA
NE1G-48T
S12-1G48T
NE100－48T
CONSOLE Port
CONSOLE (10BASE-T/
100BASE-TX) Port
AUX Port
Hitachi's Responsibility
3-3
Advertisement
Table of Contents
